Security Alarms AR6000 Betriebsanweisung

Stöbern Sie online oder laden Sie Betriebsanweisung nach Ferngesteuertes Spielzeug Security Alarms AR6000 herunter. Security Alarms AR6000 User`s guide Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 26
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
The Spektrum trademark is used with permission of Bachmann Industries, Inc.
DX5e Quick Start Guide
1. Install Receiver
Example of AR500 installed in E-flite
®
Apprentice
Though in general it is non-critical, optimum installation of the antenna is to
orient the tip of the long antenna perpendicular to the short antenna. The tip
on the long antenna should be a least 2 inches from the short antenna.
Example of AR500 installed in Hangar 9
®
Pulse
XT 60
2. Install AA Size Heavy-Duty or Alkaline Batteries
Note: Observe polarity when installing batteries.
3. Bind Receiver
A. Plug the bind plug into the receiver’s BATT/BIND port. In systems utiliz-
ing a separate battery pack and 3-wire switch, plug the bind plug into the
charge jack.
B. Power up the receiver. The LED on the receiver will be flashing.
C. Move the sticks and switches on the transmitter to the desired failsafe
positions (low throttle and neutral control positions).
D. Pull and hold the Trainer Switch on the transmitter while turning the
transmitter on. Release the trainer switch once the LEDs on the front of
the transmitter flash.
E. The LED on the receiver will go solid amber and the system will connect
after several seconds.
F. Remove the bind plug from the charge jack or bind port.
Typical Electric - Rx uses the ESC for power. Typical Glow/Gas - uses receiver pack and 3-wire switch.
4. Test System Battery Voltage
Lack of power to the receiver and servos is a leading cause of failure. If you
are using a receiver pack, ensure that it is properly charged and check the
voltage under load (HAN172). Do not fly if voltage is below 4.8V for a
4-cell pack.
In systems using a BEC, ensure that you are not driving more than the man-
ufacturer’s recommended number of servos for your BEC/Speed control.
If at anytime, the voltage should fall below the receiver’s operating threshold,
an interruption in the link may occur followed by a blinking light on the
receiver. A more accurate way to test a questionable setup is to measure the
voltage per the instructions on page 17.
Note: If the receiver power is cycled without cycling the transmitter, a blink-
ing light will also occur. In this case, this does not indicate a problem.
Cycle the Tx power, and then the Rx, to reset the light.
5. Control Surface Check
Turn on the transmitter followed by the receiver and check that the direction of each
channel is correct. Use the servo reversing switches on the front of the transmitter
to change the direction if necessary.
6. Re-Bind the System
After you’ve set up your model, it’s important to re-bind the system so the true low
throttle position is stored. If the signal is lost, the throttle servo will drive to a low
throttle safe position.
7. Range Check
How to Range Check
1. With the model resting on the ground, stand 30 paces
(approximately 90 feet/28 meters) away from the model.
2. Face the model with the transmitter in your normal flying position
and pull and hold the Trainer Switch while toggling the HI/LO Rate Switch
four times. The LEDs will flash and the alarm will sound indicating the
system is in range check mode.
3. You should have total control of the model with the Trainer Switch pulled
at 30 paces (90 feet/28 meters).
4. If control issues exist, call the Horizon Support Team at 1-877-504-0233
or go to horizonhobby.com to find a local Spektrum distributor in your
country of service.
Revised 12/08 13639.1
Pull and hold the Trainer Switch
30 paces (90 feet/28 meters)
Elevator Stick UP Elevator Stick DOWN
Aileron Stick LEFT Aileron Stick RIGHT
Rudder Stick LEFT Rudder Stick RIGHT
Leaders in Spread Spectrum Technology
Tape antenna in place.
Do not allow tip to
touch metal.
A. Insert Bind Plug
Receiver pack and 3-wire switch
B. Apply power to system
A, B. Insert bind plug into charge
jack, apply power
C, D. Pull trainer switch, turn power on
Note: Continuing to hold the
trainer switch during the binding
process will prevent preset failsafe
positions from being learned by
the receiver.
Seitenansicht 0
1 2 3 4 5 6 ... 25 26

Inhaltsverzeichnis

Seite 1 - DX5e Quick Start Guide

The Spektrum trademark is used with permission of Bachmann Industries, Inc.DX5e Quick Start Guide 1. Install Receiver Example of

Seite 2 - 2.4GHz Radio System

16 17Damage LimitsHORIZON SHALL NOT BE LIABLE FOR SPECIAL, INDIRECT OR CONSEQUENTI

Seite 3 - 

18 19SPM9520 ... 1100MAH4.8VNICDRECEI

Seite 4 - 

US Address:4105 Fieldstone RoadChampaign, Illinois 61822(877)504-0233Leaders in Spread Spectrum Technology13118.2© 2008 DSM and DSM2 are trademarks o

Seite 5 - 

ParkZone® products are distributed exclusively by Horizon Hobby, Inc. 4105 Fieldstone Road Champaign, IL 61822Horizon Hobby UK Units 1-4 Ployters Rd S

Seite 6 - 30 paces (90 feet/28 meters)

34The experience of flying just got better. The ParkZone® Radian™ encompasses all the benefits that ParkZone pilots have known to love. Experience the

Seite 7 - Elevon Wing Type Connection

56One of the most fascinating and interesting segments of RC flying is Soaring. Finding a thermal and rising without power to unlimited heights is bot

Seite 8 - Servo Precautions

78Step 1Install Transmitter Batteries1. Install the 4 new AA batteries (supplied) into the transmitter, observing proper polarity.2. Turn the switch

Seite 9 - Information Provided By

910Step 3Attaching the WingIn order to attach the wing of your Radian, please follow these simple instructions:1. Locate the wing spar, as well as the

Seite 10

1112Note: To make trim adjustments to the elevator or rudder:a. Turn on the transmitter.b. Plug the fully charged 11.1V 1300mAh battery into the ESC.c

Seite 11 - 

1314Step 7Range TestYou will need two people to perform the range test: one to hold the plane and the other to give the transmitter input.WARNING: The

Seite 12 - © 2008 Horizon Hobby, Inc

5-Channel Full Range DSM2™ 2.4GHz Radio SystemLeaders in Spread Spectrum Technology

Seite 13 - Instruction Manual

1516Step 9Step 1030A ESC InstructionsThe E-flite 30A Pro Brushless ESC is a lightweight, high-quality, efficient sensorless brushless electronic speed

Seite 14 - Radian Instruction Manual

1718Warranty and Follow-Up ProceduresWarranty Period: Exclusive Warranty- Horizon Hobby, Inc., (Horizon) warranties that the Products purchased (the “

Seite 15 - Simple Soaring

1920Request is available at www.horizonhobby.com on the “Support” tab. If you do not have internet access, please include a letter with your complete

Seite 16 - DX5e Radio System

   

Seite 17

Directives et avertissements liés à la charge

Seite 18 - Step 4 Step 5

BindingThe AR500 receiver must be bound to the transmitter before it will operate. Binding is the process of teaching the receiver the specific code of

Seite 19 - Replacing the Propeller

Receiver Power System RequirementsInadequate power systems that are unable to provide the necessary minimum voltage to the receiver during flight have

Seite 20

2  3On/Off SwitchReversing SwitchesTrainer PortC

Seite 21 - Option Parts

4 5®Your DX5e transmits on the 2.4GHz band and utilizes DSM

Seite 22

6 7: All Spektrum charge jacks are center-pin negative. This is the oppos

Seite 23 - Safety Guidelines

8 9The AR500 receiver must be bound to the transmitter before it will opera

Seite 24 - ATTENZIONE

10 11• Preventsunintentionalelectricmotorresponseon start-up.

Seite 25 - Tape antenna in place

12 133. Ifusingaregulator,it’simportanttheabovetestsaredone for an exte

Seite 26 - FCC Information

14 15General NotesRadio controlled models are a great source of pleasure. Unfortun

Kommentare zu diesen Handbüchern

Keine Kommentare