Security Alarms AR6000 Bedienungsanleitung PDF herunterladen (Seite 27)

DOTH-300

APPLICATION

MANUAL

Date

2013-07-15

Rev

1.04

Page

1-27

• Enable Aim ID: AIM ID is output.

• Return Check Digit: Transmit the symbol with or without the check digit.

• Verify Check Digit: When this feature is enabled, the scan engine checks the integrity of symbols to verify

that the data

complies with specified check digit algorithm.

• Send Start & Stop: When enabled, the start and stop character transmission.

• Convert EAN8 to EAN13: Convert EAN-8 to EAN-13.

• Convert UPCA to EAN13: Convert UPC-A to EAN-13.

• Convert UPCE to EAN13: Convert UPC-E to EAN-13.

• Convert UPCE to UPCA: Convert UPC-E to UPC-A.

• Extended UPCE: Convert UPC-E to UPC-A.

• Enable FNC1: CODE-128 and GS1-128 barcode to set the FNC1.

• System Code: Transmit the system character.

• System & Country Code: Transmit the system character and country code.

• Full ASCII Mode: Full ASCII is a variant of symbols which pairs characters to encode the full ASCII

character set.

• Min/Max Length: Minimum / Maximum length for valid barcode string for this symbol.

• Only Supplement: The scanner only decodes UPC/EAN symbols with supplemental characters, and ignores

symbols without supplementals.

• Set Space Character: Determines if there is a space character between the data from the bar code and the

data from the addenda.

¶ NOTE. The representation of active/inactive and terms Depend on the scanner model.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 72 73

Keine Kommentare

Security Alarms AR6000 Bedienungsanleitung Seite 27