Security Alarms AR6000 Betriebsanweisung PDF herunterladen (Seite 17)

Charging the Transmitter

Transmitter

It is important to fully charge the transmitter battery prior to each ﬂying session. The charger supplied with the

system (SPM7105) is designed to recharge your transmitter battery at a rate of 50mA. For the initial charge, or if

the transmitter hasn’t been used for several months, it’s important to charge the transmitter battery for 24 hours

to achieve a full charge. Subsequent charges of 10–12 hours (approximately overnight) are recommended. Many

modelers fast-charge their batteries. The DX6 does not have a charging diode in the circuit and will allow most

fast chargers to be used, however, it is imperative to understand that all Spektrum™ transmitters have a center

pin negative charge connector. When using an aftermarket charger, the charge plug must have the correct center

pin negative polarity or damage can occur.











Important

The center pin on the DX6 transmitter is negative. Beware of improper connections based on “color code”

wire leads, as they do not apply in this instance. When using aftermarket chargers, you must make certain that

the center pin of your Spektrum transmitter is always connected to the negative polarity for correct hookup or

damage can result.









SPEKTRUM DX6 • INTRODUCTION

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 95 96

Keine Kommentare

Security Alarms AR6000 Betriebsanweisung Seite 17